These are the files for the fns mag holster designed and brought to
 life by 3d_phucking 
 and TMS the files contain the clips and body for the mag holster
 THIS DESIGN HASNT BEEN TESTED ON A FNS9 BECAUSE I UNFORTUNATELY DIDNT-
 -HAVE ONE,

    the recommended print setting for the body and clip are 
 esun PLA+ OR TRUSTED FILAMENT ESUN IS JUST WHAT I RUN
 HOTEND:220C,
 BUILD PLATE:60C
 plate adhesion: skirt
 60mm/s is what i found success with little stringing
 
     you will need a file set and some spray lubericant of your choosing
 make sure to do a decent amount of filing as it is a flush fit
 and WILL NOT WORK IF NOT FILED A LITTLE BIT,
 i have broken bodies and the still hold the clips so once its in there-
 -its a bitch to get out,
 
      you should also expect the mag to remove some material if not put-
 -in the holster right its a tight fit to keep bulk down,
 i havent noticed any malfuctions because of material being removed when
-inserting the magazine,
  
               AND REMEBER TO BE EXCELLENT TO EACHOTHER.
